Latest Blog

Key Takeaways – Implementing recycled plastics in HVAC requires strict quality control on Melt Flow Index (MFI) to prevent inconsistent molding pressures. – Post-Consumer Recycled (PCR) materials often require “compatibilizers” to maintain impact strength in structural components. – Bio-resins like PA11 (Castor Oil-based) are viable for specific high-heat spacers but remain cost-prohibitive for large housings. […]

Key Takeaways – Insert molding HVAC parts provides superior pull-out strength and torque retention compared to post-process heat staking. – Pre-heating metal inserts is critical to minimize residual stress and prevent “hoop stress” cracking in the plastic boss. – Component assembly reduction is a primary economic driver; integrating fasteners during molding eliminates secondary labor. – […]

Key Takeaways – HVAC rapid prototyping (SLA/SLS) validates geometry and airflow paths but rarely duplicates the chemical resistance or thermal stability of final molded parts. – Mold flow analysis is the critical “digital bridge” that predicts warpage and gate locations before any metal is cut. – Using “Soft Tooling” (Aluminum 7075) can bridge the gap […]

Ключевые выводы – Химически стойкие пластмассы должны выдерживать не только хладагенты, но и синтетические масла (POE/PVE), циркулирующие вместе с ними. – Выбор материала для поддона конденсата на многих заводах сместился с АБС на полипропилен (ПП), чтобы предотвратить растрескивание от остатков масла. – PEEK против PPS: хотя PEEK обладает превосходной пластичностью, PPS является отраслевым […]